- Experience & qualifications -

• Process Control systems:
  • Complete Instrumentation & Control system Engineering
  • Biddable Drawing preparation - P&ID's, Loop drawings, Indexes, Schematics, Plans, Panel Layouts, & Installation details
  • Biddable Specification preparation - for instruments, equipment, installation, and third-party systems & services
  • System Architecture selection / design
  • Networks design & configuration
  • Systems Integration
  • I/O configuration
  • DCS, PLC, & SLC configuration and programming
  • Operator Interface design & configuration
  • Multiple High-level language capabilities
  • Safety Instrumented System design: SIF evaluation, LOPA & SIL calculations
  • Full commissioning, calibration, tuning, startup, and documentation
  • Panel fabrication (subcontracted)
  • Field support
  • Progress inspections
  • Registered Professional Engineer
  • Member ISA
  • (occasional) Member TAPPI
• Power distribution - low & medium voltage to 35kV
  • Complete Electrical system Engineering
  • Biddable Drawing preparation - Single-lines, Elementaries, Schematics, Plans, Risers, Panel Schedules, and Installation details
  • Biddable Specification preparation - for distribution gear, MCC's, equipment, installation, & third-party systems and services
  • Protective relaying
  • Power system monitoring
  • Distributed billing
  • Standby / Emergency / Co- Generation
  • Short circuit analyses
  • Load studies
  • Arc Flash Hazard evaluations
  • Coordination studies
  • Cable pulling calculations
  • Drives selection and configuration
  • Heat tracing
  • Lighting design
  • Fire Alarm systems design
  • Paging / communications
  • Lightning Protection systems
  • Registered Professional Engineer
  • (occasional) Member IEEE
• Electronic Circuitry
  • Analog and low-speed Digital circuit design
  • Embedded controller Programming
  • 2-sided PCB layouts
  • Prototyping & Testing
• Training - Operations and Maintenance
  • Operating Procedures
  • Troubleshooting Guides
  • Classroom instruction
• Project Direction
  • Performance Specification Writing
  • Scheduling
  • Cost Estimates
  • Electrical and Instrumentation On-site Construction Support
  • Requisitioning / Procurement